Fault codes / Lippert Level Up
Lippert Level Up 5th wheel auto level fault codes
Lippert (LCI) Hydra-Electronic 5th wheel leveling is a 12V DC electric/hydraulic system. It has two front hydraulic jacks, rear hydraulic jacks and rear electric stabilizers. A touch panel runs it, with ON, AUTO, MANUAL, FRONT, REAR, LEFT, RIGHT and RETRACT buttons.
Lippert Level Up: 2 flashes
Satellite sensor problem. Inspect the satellite sensor and its harness connections. Reset with RETRACT.
Lippert Level Up: 3 flashes
Internal sensor problem. The internal sensor is in the controller. Reset with RETRACT and retest. If it repeats, suspect the controller.
Lippert Level Up: 4 flashes
Low voltage. Charge the battery and check power and ground connections at the pump.
Lippert Level Up: 5 flashes
Out of stroke. A jack ran out of travel. Move the unit to more level ground.
Lippert Level Up: 6 flashes
Panic stop. An operation was stopped. Reset with RETRACT.
Lippert Level Up: 7 flashes
Jack timeout, leveling took too long. Check fluid level, voltage and the jacks for binding.
Lippert Level Up: 8 flashes
Auto level failed. Check site slope and zero point, then retry after cycling main power.
Lippert Level Up: 9 flashes
Stabilizer timeout, stuck or hitting. Look for a rear stabilizer that is jammed or hitting something.
Learn the system
- How a slide room is built and carried
- Identify the slide system in a minute
- The in-wall controller: versions and fault codes
- Ball-screw actuator slides: clutch, stops, diagnosis
Practice it on a service call
Guided diagnosis
Full field guide: Lippert Level Up 5th wheel auto level
Codes come from the maker manuals and public service sheets. Your model's own chart always wins, and LP and 120 volt work belongs to a qualified technician.